STEP 1 : Unfold the deflated boat
Clear a flat space (making sure it is clean and free of sharp objects that could damage inflatable boat) and unfold your boat. Remove the hull from its box (or storage bag) . Unroll the hull of the inflatable boat so it laid out flat.
STEP 2 : Inflate boat air chamber to 30% and unroll air floor
Push and twist all valves one quarter to the closed position. The Inflatable Boats can be inflated either with a foot pump or with electric pump. Inflate all main chambers to approximately 30%-50% full. Unroll high pressure air floor into the boat.Floor has plywood support board which will push keel down and create V shape on the boattom of the boat.Be sure not to trap the tubes under plywood support board.
STEP 3 : Make sure that keel valve is located at the center of the floor hole
Install bench seat(s).
STEP 4 : Inflate main air chambers
Inflate main air chambers. Do not inflate one air chamber at a time. When inflating or deflation pantoons , maintain a balanced air pressure between chambers in order to prevent potential damage of the pvc wall inside of the chambers that separate the air chambers .
STEP 5 : Inflate high pressure air floor and keel
Once main chambers inflated ,inflate high pressure air deck .Please refer to the chart on the bottom of the page for air pressure or visit. Do not inflate keel until air deck is inflated .After you have inflated high pressure floor you can start inflateing the keel.
|
MAXIMUM PRESSURE FOR INFLATABLE BOAT |
RECOMENDED PRESSURE FOR INFLATABLE BOAT |
| TUBES / CHAMBERS |
3.6 PSI (Pounds per square Inch ) or 25 KPa |
3 PSI (Pounds per square Inch ) or 20 KPa |
| |
|
|
KEEL |
5 PSI (Pounds per square Inch ) or 35 KPa |
4.3 PSI (Pounds per square Inch ) or 30 KPa |
| |
|
|
| HIGH PRESSURE INFLATBLE FLOOR |
10 PSI (Pounds per square Inch ) or 70 KPa |
8.7 PSI (Pounds per square Inch ) or 60 KPa |
To Buy Mercury Inflatable Boat in India Contact Us @ 022 6677 6659
|
